Fill In Engraving

[eflyguy]

If you were talking about adding to your design and needing to line things up, here’s the method I had in mind:

Align artwork after it's been moved

I’ve used this technique to add components to a design, which is what I will demonstrate here, but you could possibly use it to re-cut a design that did not cut all the way thru. Here’s an example where an outer circle was not added to the overall design, and needs to be scored: [IMG_6700] First, you need a couple of pieces of scrap that are the same height or a VERY tiny amount thicker than your original material. In this example, I’m using chipboard, so I just grabbed a couple of scraps. L…