Fusion 360 Parametric Kerf Help

[Jules]

Just so happens I did a write-up on that a while back:

Adjusting for Kerf in your Design Parametrically - Fusion 360

I was going to link to another topic that has (once again) disappeared, so be sure to check out the tutorials on kerf from @smcgathyfay and @Hirudin for a discussion of what kerf is, and how it impacts design. If you’re just getting into Fusion 360, a good way to pick it up quickly is to watch a few of the Fusion 360 Training tutorials on YouTube: . . . Okay adjusting your sketches for kerf is fairly easy. If I had something like a hole that had to hit an exact diameter after cutting,…