Glowforge lid calibration beta

Just ran the lid recalibration on my glowforge. before, the prints were as much as 1/4 " or more off from the preview image. After calibrating, it is dead center of the test pattern! Great job GF staff!!

14 Likes

You do realize this has been around since 2019?

2 Likes

Yes I do. However this is the first thing that has made a significant improvement in the accuracy of my GF alignment since I got the unit, and from what I’ve read, this is still a big issue for newer owners. Also it took this long to stumble across this solution, so I will say it again, whether first introduced in 2019 or 2021, good job GF techs, we’ll earned kudos!

10 Likes

I’m so glad it was helpful! I will share your thanks with the team.

4 Likes

This topic was automatically closed 32 days after the last reply. New replies are no longer allowed.