Help Engraving Ikea Aptitlig Cutting board

[eflyguy]

The surface of the tray is around 1.5" above the floor of the machine. It can only “print” from that height up to about .5" higher. So you need to prop your material up so that it falls in that range. You enter the height it now sits above where the tray surface would have been.

Here’s one (of many) solutions to supporting material:

No crumb tray solution

Here’s my solution to hold items with the crumb tray removed. The top of the top step is equal to the height of the crumb tray. To get the setting for the materiel height, just measure from top step to top of materiel. The circle in the middle is a deep engrave to hold a magnet. The steps are friction fit in the base and I remove them and use the magnets on the crumb tray when needed. [magnet%20thingy1][20180222_200654][20180222_200756][20180222_200826]