Hiding a power supply


#1

A builds go, this is still a little ‘work in progress.’ I have a lot of wiring clean up to do in the back before adding a new panel between the wiring and tempered glass and a few other things but…

The front cover for the power supply came out really nice. If I had it to do again though, I’d make a better jig to bend the :proofgrade: acrylic with. Bending a 19.25" long panel over 3 ‘spines’ produced a few pinched looking points and a subtle wave in the front of the panel. Lessons learned :slight_smile:


#2

Looks like you might not have heated the acrylic evenly. Or didn’t have sharp edge on the jig you want to replace.

something to look at when you plan your next one.


#3

Well, I’m impressed! :smile: