My replacement arrived today and cuts great. On the other hand same issue blurry camera so it wont select the PG material but like i said before i don’t mind selecting the material as long as i can get my products out. I’m just grateful i have it back…
7 Likes
Did yours get repaired or did they send a refurb?
1 Like
if it’s refurbished i can’t tell it…
That’s encouraging. There have been a lot of unflattering descriptions of replacement units posted.
2 Likes
My refurb replacement was pristine. I’m just now starting to get it good and dirty. 
2 Likes
Mine was too but camera still blurry and doesn’t read the QR Code. But just like my first one not a big deal, just select the material…
Mine’s fine. Alignment is good so far. Haven’t done a full bed test. Mine seems pristine.
1 Like
The camera turned blurry a few days after I got my replacement. And lots of complaints suddenly popped up in the forums. I’ve chalked it up to something that happened in a software update. 
2 Likes
This topic was automatically closed after 32 days. New replies are no longer allowed.