How to cut multiple designs

[evansd2]

@mrinken

like the latest peg board hooks I can’t seem to get enough of

If you’re cutting a lot of parts, there’s no substitute for organizing them in your design software. Check out the tight hand nesting on this one.

How to remove masking from 423 parts at once

I’ve mentioned my tape sandwich method before: Mask your material. Cut. Apply blue painters tape to the entire surface before you remove the material. Remove taped-up piece, all the cut parts should come with it. Flip and tape the other side. Now you have a tape sandwich. [image] Press the tape down thoroughly like you’re applying masking. Peel the blue tape and masking off in a sheet. [image] You’ll miss a couple pieces, but that’s ok. It’s like 98-99% effective, which is good enoug…