Intricate wooden puzzle

Everything Else
1

Donā€™t recall seeing this on the foraā€¦

http://imgur.com/xqtliyz

21 Likes
2

The endlessly-watching eyes of the Glowforge faithful miss nothing :wink::

12 Likes
3

So (referring to the kerf discussion)how would something like this compensate for kerf? I would assume you would cut it from one piece, cutting ā€œonā€ the line. Would the kerf just be negligible? these pieces seem pretty darn precise. :confused:

1 Like
4

I think if you compensated for kerf the pieces would be very hard to make fit!

5 Likes
5

Wouldnā€™t want to compensate for kerf on this. See how the pieces just drop inā€¦thatā€™s the beauty if it.

2 Likes
6

The piece just disappears into the puzzleā€¦ absorbed.

3 Likes
7

So youā€™re saying itā€™s just cut on the lines and the kerf is small enough for a nice fit (and lines are pasrt of the piece actually).

8

If you picked it up, the pieces would probably fall out if it was flat. But for this particular application it works perfectly. They would wiggle just a bit if you moved them, but a very little bit.

1 Like
9

This is so satisfying to watch, for some reason.

2 Likes