Johnson Plastics Duro Board Settings

[misdixon]

Has anyone worked with the Duro laserable wood laminate from Johnson Plastics?
Looking for some good settings if anyone has worked with it.

TIA!!! I am new to using non PG material and figuring out my own settings.

[rbtdanforth]

@misdixon

Looking for some good settings if anyone has worked with it.

This will help you find the settings for anything

Depth Adjustments

Based off @evansd2 design I now am using this. … [evans%20tests] This cuts the design across the engrave but leaves enough at each cut to not fall to pieces. The engraves are twice the speed of the cuts so they make the same array.

[bwente]

With my Glowforge Basic I have used 160-165 (depending how dusty my lense is) for the speed and the power at full for cutting the black duro board. It was the 0.125 in boards.

[misdixon]

Thank you!!!

I appreciate the suggestion!!!

[misdixon]

thank you so much!!!