Laser cut on silicone

[andistarnes]

This wasn’t done on a Glowforge, but check out what @smcgathyfay did here:

Laser etched silicone cup bands

Since the cup was slightly at an angle I took the band off and taped it down flat so it can easily fit in the glowforge. I got little lines I think because it wasn’t taped tightly enough and it bowed up a bit in the middle. Lesson learned for next time. I used the silicon stamp setting. It had a little bit of dust but not too bad. I just cleaned it off with a toothbrush and soapy water. $3 cup from Target…could sell for $15 [image]