My daughter asked me if we could cut a pumpkin on the Glowforge. I said “sure” … a couple of hours later, we had this. I’m not sure if that’s what she had in mind.
You can see an assembly video here: https://youtu.be/qPPf0JtAPJ0
You can also buy the design on my Esty store: https://www.etsy.com/ca/listing/870918400/low-poly-pumpkin-lasercut-design-files
I’ll bet none of your neighbors have one of those. Are you going to put a light in it?
I was thinking orange acrylic…
There is nothing to dislike about this. Very nice, indeed!
Ohmygosh, that is so cute! I’ve never seen a piece like this—well done!
This is putting me in the spirit of Halloween!
That is definitely a different take on cutting a pumpkin on the laser! Those are some interesting joins to go with it, very clean look.