Just starting on Glowforge. Monogrammed this cutting board. Happy with the turnout
25 Likes
What a pretty board! Great results! 
2 Likes
Thanks very much!
Looks very good! Nice design layout!
1 Like
How thick is your cutting board if you don’t mind me asking? Looks awesome and thanks for sharing.
1 Like
Beautiful
1 Like
Thanks very much
It was 1/2” thick
1 Like
Thanks
Ooh!Great work! The grain of the board is super nice!
2 Likes
What where your settings so beautiful
Thanks very much. Speed was 1000 power 40. For a bit darker I could have gone up in power. It I liked the finish at 40
Chuck Buckland | General Manager- AVL
40 Lindbergh Lane
Fletcher, NC 28732
828-687-7110 Office
828-490-2402 Cell
Chuck.Buckland@signatureflight.com
Looks good, did you do a final Score pass after engraving?
We left It as is for this one. On future ones I plan to go a bit darker.
Chuck
Something to try is to Score once the engrave is complete and do a pass using the same power setting. I find the scoring makes the shallow engraves really stand out and make it nice and sharp.
1 Like
Great tip. Thanks for sharing. I will try that next go around.
Chuck