Mylar Cutting With Aura

[evansd2]

This has been discussed before, I think this thread will be of some help:

Mylar for Aura

Hi. Someone asked me to cut out some stencils for them on my Glowforge Aura using Mylar sheets from Amazon. I did an online search, and a search on the forum but I still cannot find out if Mylar is safe to use on my Aura. I know I can’t cut white or clear acrylic so I was assuming it would be the same problem but does anyone know for sure? Thank you!!

Good luck! (and if you try the black variant let us know how it goes)