Not printing where I indicate

[dan84]

Some reading if you would like a more in-depth explanation of #2

Calibration Issue or Aligning Issue

Warning: long explanation incoming. There’s a camera on the lid of the machine pointing at the crumb tray. It takes a picture of your material, which shows up on the GF application, bordered by some rulers, and you line up artwork with your material that way. But how does the Glowforge know how big or small to make the camera picture so the rulers are accurate and you’re lining up your artwork with a life-sized image? After all, the same 4 inch square of wood would look larger than 4 inches if…