Pass through slot help with

[rbtdanforth]

@margaretrgriffith

I am a visual learner…

I am also a visual learner but most of the pictures are in my head
This will make such measurement as you need, and you can apply it as you need.

Oops forgot the link…

Two sticks to rule the world

Well, the world inside a Glowforge anyway! Having some scrap plywood I thought to make a 20-inch ruler that would define the space available and set accurate measuring points, I set Inkscape with a 1/10-inch grid and a snap-to-grid so they were dead on accurate and as I was doing it realized that I could not engrave or even cut the full length, so I measured a horizontal line as close as I could get to the max cut area, and cut the rulers down to that. I could not decide which side to put the i…