Pool Cue

Segmented pool cues fit perfectly in the glowforge



These are the cues:
https://www.amazon.com/gp/aw/d/B07L5RMKBG?psc=1&ref=ppx_pop_mob_b_asin_title

Settings were 900 speed, 60 power, 270 LPI

Using the grid jig made a difference with lining it up perfectly but I have noticed the recently app updates are much much better at handling the fisheye distortion. The app showed it to be pretty darn close to what the real coordinate was.

26 Likes

Cool, and I love your ‘instructions’ :rofl:

3 Likes

Very nice. Though I think I’ll not be trying it on my 3000 dollar pool cue. :rofl:

2 Likes

I’m not sure I’d be trying anything with a $3,000 pool cue. (Including using it to hit the white ball!)

8 Likes

I don’t break with it. But I do use it for everything else. :smiley:

Custom Chester Krick. But I fully admit that anything over about 500 dollars is just vanity. They don’t help your game at all.

5 Likes

I could see where this could be very good for custom cue makers to put their “mark” on the butt. Probably not something you want to do to the shaft though.

3 Likes

Slick, and a nice “Pointer” :slight_smile:

I will use BEAMER to make the light for my table.

2 Likes