I’m happy to stand corrected. I’ve just never been able to replicate a glass-clear, crystal-like engrave as shown in the OP’s link to a product.
3 Likes
Maybe a 3D engrave the thickness of the material with a slightly inset final cut line following the facet outline?
Flame treating the final piece with a quick pass through a propane torch might be quick & easy and results in clear polished edges on acrylic.
5 Likes
I have tried that and it never worked out. It “softened” the engraved surface but never came out “polished”… Not only did it not make the engraved areas clear as I had hoped, it also marred up the adjacen flat surfaces that were previously clear.
Perhaps I just suck, but I gave up.
4 Likes
This topic was automatically closed 32 days after the last reply. New replies are no longer allowed.