Sample rubber arrived, suggestions on power and speed needed

Just got a 2"x2" sample of 3/32 rubber. I want to do a simple test (probably just cutting out a circle) to see what the affect is to the material. Since I don’t have much material I was wondering if anyone could suggest a starting point for power and speed.

1 Like

Several folks have tested rubber and I think it depends on where you got your material. This might get you pointed in the right direction though.

https://community.glowforge.com/search?q=rubber

1 Like

Thank you.

I ended up opening a beer and just hacking away at it. Stuff cuts nice and any discoloration rubs right off. Definitely a fan of the stuff.

2 Likes

Hahahaha That sounds like a perfectly viable option! Look forward to what you’re gonna do with it.