Simple drying/finishing rack for small parts

[Purplie]

Couldn’t find anything that was quite what I wanted, so…

[evansd2]

Nice little rack. In version two if you angle your rows by something like 30 to 45°, you’ll get true pin bed status. Angling them will have your parts resting on the tips of the cut points which are essentially at that point tiny pyramids.

[Purplie]

Good suggestion. I’ll see how this version does… One thing I intended, but forgot, was leaving gaps in the base for air circulation. Doh.

[dklgood]

Nice practical cut. Thank you!

[ptodd]

Thank you for sharing this! It could come in very handy.

[rvogt]

Thanks for sharing. Nice design.

[ellencadwell]

Very handy, thanks for sharing!

[ota2]

Cool, thanks!

[cynd11]

Awesome, thanks! And it you cut it out of Delrin, no glue will stick to it.

[Purplie]

@cynd11

cut it out of Delrin, no glue will stick to it

Oh, thanks for that tip!

[kelley1]

Thanks for the share–a great way to use up acrylic I don’t like.

[daltonspdx]

Oh! I made a collapsible tiered drying rack that’s a similar idea. These would make ace inserts for the smaller items. I shall have to share it tomorrow. Might have to tweak a few measurements first.

[ChristyM]

Nice share. Thanks!