Well working with some stainless steel, we had the laser do some…unexpected behavior. See the attached photo.
It’s almost like the laser ‘skipped’ along. Though, using the same file at slightly different speed and power settings, everything worked fine.
Any ideas what cause may have been
?Were you using cermark or something similar to mark with?
Not sure that you’ll get help from support on this one. You may get bumped to #beyond-the-manual
@jbmanning5’s right.
Since this problem is being seen on materials that were purchased from another company, we can’t offer support for prints that don’t come out as expected. I’m going to move it to Beyond the Manual so other folks here can help. Should this happen with a print on Proofgrade materials, please open a new ticket in Problems and Support and we’ll help you right away!
