The Aura is very new so no spreadsheet has been done to my knowledge. You can create one in your GFUI by saving the settings when you get a good result. The key to a good list is the naming. Material- look(light deep etc) LPI - speed - power- times, will sort itself to be easy to find. (of course with cutting LPI doesn’t count) The /cut-score - engrave / is already separated
there are a lot on my list that would not interest the community or be dangerous if not watched like a hawk…
Acrylic-vary power
power- full
LPI- 1355
speed-2500
Light touch shiny result (not for narrow designs near a corner)
No, they are settings I use in a pro. The point is that very few folk go to 1355 LPI but I do frequently as it captures much better detail . This took an hour and 20 min with a speed of 2619, full power, and 1355 LPI for a 4"circle