New to glowforge and a friend just became a nurse , would love to engrave a stethoscope for her graduation gift.
I do see someone has done it previously ,
Anyone like to share the settings ?
It’s totally going to depend on what steel your particular scope was made from - I’m afraid you’re going to have to test to get a good answer. This thread links to a bunch of marking steel posts. Read through these and you’ll get good advice as to where to start!
Is the tubing made of silicone? That can be engraved if you have/make a jig. (Gotta make tools for your tools.)
Welcome to the forum!
Hmm that’s interesting, I’ll have to research if it would mess with the integrity but perhaps for a decorative one framed or in a shadow box
Post a photo of the stethoscope! At some point I would like to engrave mine also.