Tutorial on Etching Tile

[evansd2]

@goodthings

And, for the cardboard jig, is there a file that shows how to lay out the jig?

Not really.

There are a ton of posts about jigging, but I tend to prefer what I call a “corner jig”.

I posted about it here:

Alignment of irregular objects (Coasters)

I got a set of slate coasters. Unfortunately slate’s a pretty analog material, and each square was very slightly different. Under normal circumstances, this would not be an issue, as the differences were very small… but these are to be a matched tiling set, and so alignment was crucial. The way I solved for it was to make a “consumable” jig. Carefully measure your coaster: length, width and height. Be sure to mark the bottom somehow so you know your orientation later. Go to your favorite S…