@Rita thanks for the followup. I haven’t had a chance to play (a newborn keeps us busy) but I’ll try soon. Everyday I think “something is getting lasered tonight” but then I come home from work and he falls asleep on my chest. 
7 Likes
@Rita I ran a couple of jobs on PG tonight and didn’t get the cooldown error. In fact, one was double sided and I was just taken right back into the GFUI after the first side was done. I’d say go ahead and close this and if I run into it again with non-PG, then I’ll know it’s isolated to that.
The back side had the same engraving and while the alignment was off a bit on screen for the back, I didn’t touch the placement and it engraved fine. Although had others here not pre-suggested that in this thread, it would have been pretty frustrating and required at least one do-over.
4 Likes