"Always Right" Honeycomb Pins for Assuring a Right Angle

How do I download this? I can’t seem to find the download link.

Read two posts above yours for directions.

2 Likes

I have to tell you, this is a life saver! Thank you so much. I’ve been struggling with magnets and old style hold down pins for a long time. These (new style) printed perfectly and they’re so cute! Thank you again!

4 Likes

Where is the SVG file?
Thanks,
Gale

Right click on the image and “Save image as…” - it’ll save it as an svg file to your computer.

1 Like

This is so awesome

I made these on 1/8" bamboo, so they hold up better than draftboard. They’re awesome!

BTW My settings for engraving and cutting the 1/8" bamboo were:

Engraving: 1000/90/340/1
Cutting: 170/100/1
I set my material thickness at 0.128 to compensate for some slight warping with the thin material nto be sure it cut through.

1 Like

Thank you for this file! Just what I needed and worked like a charm… THANK YOU THANK YOU!

4 Likes

Welcome to the forum.

1 Like

I HAVE SCROLLED this entire page and I cannot find the actual file :confounded: would love to try this out

Near the bottom of the original post.

3 Likes

I agree :100: ! I also like to cut my designs with corrugate first so that I know exactly where to glue/stick the final design down when layering.

1 Like