Anodized Aluminum Flash Drive Engraving

I am pretty pleased that these were so successful on the first attempt!

I used 200 (speed)/100 (power) on 1 pass. The Evermore Studio ambigram logo was a vector “score” while the spirals were an engrave at 225LPI.

I cut a cardboard jig for holding and positioning, then used the paper marking technique to align it. Here’s a shot of the setup:

33 Likes

Great job on it! (And nice jig work.) :grinning:

4 Likes

These are great. Do you have a link to where to buy the flash drives?

1 Like

Wow, that really came out nice!

2 Likes

Certainly!

(Associates link supports a local arts org.)

Available in other colors, of course.

3 Likes

Stellar! It really pops!

Wonderful thanks for the link. Its going on my Amazon “glowforge” wish list.

Hey - thank you for your settings! Worked perfect for my keysmart keyholder :slight_smile:

1 Like