BUG: After cool down, GFUI shows the job as stopped but it does finish

Community Support
1

This seems to be the same problem as:

My office is small, and had to open the door to cool the room down, but as it was finishing, I was trying to see how far along it was, and it was frozen on where it was when it needed to cool down.

image
image1342×745 143 KB

Since this occurred just like the closed one, I made a new topic as suggested in the other post.

The print was started at around midnight central time (San Antonio, TX)

2

I’m sorry you ran into this issue. Thank you so much for the details. I’m looking into it now. As soon as I have more information I’ll update this thread.

3

After further investigation, we’re seeing this, too. We’ll continue looking into it.

I’m going to close this thread - if the problem reoccurs, go ahead and post a new topic. Thanks for letting us know about this!