I’m so sorry for the snag you’ve hit, but I appreciate you providing the screenshot of the workspace inside of the Glowforge App.
Your Glowforge bed can accommodate materials measuring 18 x 20.4”. Your Glowforge has a maximum printable area of approximately 11″ (279 mm) deep and 19.5″ (495 mm) wide, and it’s reduced somewhat when the laser operates at high speed, as it can take space for the laser to decelerate.
This means not all of the bed is displayed, or available to be printed on, so there will always be about an inch of space on the left. This material can be reused as scrap later for small pieces. For example, a lot of customers use small pieces of scrap to print these pins available in the free laser design section: Honeycomb bed holdown pins
I hope this information helps! Based on the log files we’ve extracted from your unit, your lid camera does appear to be working within specification. I’ll close this thread for now, but if you happen to run into the same trouble, please don’t hesitate to reach out to us directly at support@glowforge.com if you run into any more trouble. We’re here to help!