Please see below photo, the big problem can be seen when engraving the square, it stopped and started skewing off. This happened with every engrave it randomly starts engraving in the wrong area, my files are right and the boards are flat. Any ideas why?
Have you printed the gift of good measure on proof grade material it that comes out correct then odds are 99.89% that it’s not the Glowforge. if you would be willing to post that file here someone can take a look and see they find something you did not see.
1 Like
What are you using to hold the board down? Any chance the printhead hit something and veered off?
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.