Filter for the old gen 1 GF?

[cynd11]

If you’re looking for an adapter STL, there are at least a couple that have been shared in this forum:

Quick-connect exhaust port adaptor

As recommended, I disconnect the exhaust hose from the Glowforge when not in use to keep bugs, critters, etc. from gaining access to the interior. I got tired of trying to get the hose on and off, so I designed and 3D printed an adapter that uses a taper fit to simply press on to the exhaust port. The other end accepts the stock exhaust hose and spring clamp. has never popped off once, but is easy to remove by hand. I have included the .STL file if anyone has a printer and wants to make one. …

3D modeling approach for flange design?

Some measurements for dialing in the flange extender. [IMG_0210] I went with a 3mm thickness to account for the slight draft to the flange [IMG_0211] I didn’t include ID for my variables. Just OD, thickness, flange base and flange extension, an inner dimension and an outer plus base thickness. [IMG_0213] Used 97mm for OD. [IMG_0215] The depth of the outer flange wall to case I used 13mm to not have it bottom out. Holds on snug with that amount of vcontact area. [IMG_0218] The are 10…

Or here is a parametric hose adapter on Makerworld so you can tweak your own STL:

https://makerworld.com/en/models/1599304-parametric-hose-pipe-tube-adapter-connector?from=search#profileId-1685445