Glass engraving revisited

[deirdrebeth]

Instead of scouring the world wide web, try searching for glass settings here. There is always some variation as every machine is slightly different, but this might get you started:

Glass Etching Shot Glasses

I was told this wasn’t possible. Well here it is. Takes about 10 runs: mask with removable tape or label. Start with 600/Full/340 then gradually lower the speed each run to 300/Full/340 and then use 200/Full/450 on the final run. All glass acts differently so you might have to try a couple to get the science down. You’ll have to gently remove any glass flakes left over for a clean look [image] [image] [image] [image]