I recently moved so my GF Aura was not in use for a few weeks. Packed it up per instructions in original box. Unpacked it and it worked fine. Went to use it today and when it started to print, black ashy residue started coming out in chunks. I immediately unplugged the machine. I had cleaned the air assist fan before we moved but thought I better clean it again. While there wasn’t much new residue the black chunks just kept falling out of the bottom of the print head. I cleaned it well put it back on and the air assist fan does not spin. I only cut basswood with it. I’ve tried everything and still no luck any ideas?
2 Likes
All is good! Cleaned it again and its up and running!
7 Likes