I did find a possible clue when I tried to open the Fusion Hole.svg file in my version of Inkscape (v0.92.1 r15371).
I got this message when the file opened:
:
If you ignore the message, the file opens with an incorrectly sized result:
But if you choose either Set Viewbox, or Scale Elements in the popup when you open the SVG file, the sizing displays correctly in the Inkscape display:
And the results of those are reflected correctly when the file is loaded into the GFUI. The Inkscape file that had 90 ppi input into Inkscape was sized smaller than the ones that were scaled correctly at 96 ppi input.
Couple of questions…
- @miskaye…what version of Inkscape are you running? Is it an older version?
- Did you get that SVG file from somewhere else? (Download off web or anything along those lines? It might have been created with an older version.)
- If you wouldn’t mind zipping up your DXF file from Fusion and uploading it here, I’d like to run a couple of tests on the original file to see what it does. I almost feel like there’s something just out of reach…almost got it, but not quite.