Glowforge slipped while cutting

[scott.wiederhold]

@takitus

I know @jbv has experienced this, and I have lost a couple sheets of material to it as well.

Me too:

Discussion of June '17 update

After a power cycle, and calibration, it is still doing the same thing. You can see the head hit the door when it reaches the end of it’s Y move, and then it appears to tip back to normal after it begins the X move. [Glowforge Head Bump] Here are the witness marks on the head: [43] Here is the result of the bump on the cut: [01] As a side note, of little importance: I did about 10 power cycles yesterday testing repeat-ability of the homing process (around ±.004" on my machine,…