Got a few hours to spare and want to clean up your honeycomb tray?

[eflyguy]

I found the thread on the passthru issue and my solution. I highly recommend it. I rarely use that feature but almost every time I did, the “gap” between the tray and slot was an issue…

Passthrough - one solution for issues with cut parts jamming

When cutting designs with small cut pieces, as you move the material forwards thru the slot, they can drop into the space between the lower door and the crumb tray, “jamming” the material. My solution was to make a piece that fills the gap, allowing those parts to stay in place until they slide through the slot and out of the machine. [image] (my shapes are off, this was just to illustrate the idea) I ended up with a pretty simple solution - a st…