After I hit the print button I notice the design shifts slightly down and to the left from its original location in the GUI. I am still having the same result after I cleaned the optics.
In order to compensate, I have to hit cancel and then print again. The design does not shift on the second print. Does anyone know what could be causing this? It is a headache because heightwise my design takes up all the available printable area.
Thank you for any help.
Brant
Does it still do that if you use “set focus” and watch for the red laser to hit your material before you move the image into place?
As above. Use set-focus before you locate your design.
The design isn’t shifting, the camera is adjusting the image based on the measured height of the material if you didn’t specify it manually.
Using set focus as stated above will fix all your problems 
I see. I’ll give that a try. Thank you everyone for the feedback.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.