Is this ok to laser

Community Support
1

Hello. I have a few items that I have already sprayed Rustoleum lacquer on the back and want to engrave a makers mark on the back and did not think to before spraying. Is this product safe for me to laser? Link to product: Amazon.com

Thank you in advance!

2 Likes
2

The Material Safety Data Sheet will have combustion by-products in there somewhere, I’ll let you read it. :wink: You probably know that chlorine is to be avoided.
(The MSDS is a thing. You can Google that for practically any product)

6 Likes
3

Thank you for the reply and link. I did read it but I am afraid that I don’t know enough about what I am reading to determine if safe to do or not unfortunately though.

3 Likes
4

Perfectly safe. And you can respray the engraved mark afterwards and the new lacquer will melt into the previous layer giving you a nice finish.

10 Likes
5

Ok great. Thank you so much. I was not sure what to do. Thank you again.

1 Like
6

I would ,make very sure it is dry before engraving as the solvents are very flammible,

6 Likes
7

Thank you. This is stuff that has been done for over a week.

2 Likes
8

This topic was automatically closed after 30 days. New replies are no longer allowed.