Lessons Learned - Newbies

[evansd2]

@samrcawley

Use colors to split a job into parts, but remember the color you used because having 5 “blue” values off by one number each is a pain to fix (and color pallets vary slightly based on CMYK vs RGB).

This is why you should use a custom palette. Problem solved and helps keep your steps in the correct order in the UI.

Custom Inkscape, Illustrator, CorelDraw and Affinity Designer Color Palettes for ordering operations in GFUI

Continuing the discussion from Space Invaders or Mitral Valve Leaflets, you decide: I have always been curious about how the Glowforge defaults the order of operations. I have tested it in terms of position in the workspace and order of creation in the design. Nothings seemed to click right, but I had a sneaking suspicion that it was dermined by color. The Glowforge catalog designs always load in the same order, though you can drag and change them in the workspace, so I figured there must be so…

You can also generate your own with something I made:

Inkscape custom palette generator

So the key to a good GF palette is that your colors must be pretty different from each other, and in ascending hex code order. The colors being different from each other helps you differentiate between them at a glance, the hex codes in ascending order is for the GFUI, it sorts colors from low hex value to high. I built a page that generates a ton of colors and presents them in order, allowing you to click and select colors and fine tune your options to ensure good contrast. To use it, downlo…