Make an airfilter?(Just need the smell gone)

[evansd2]

@shop knows his way around filters… There are commercial alternatives.

Previously discussed:
https://community.glowforge.com/search?q=DIY%20filter

Also previously discussed:

Third Party Air Filter

I have a Pro unit on the way, and with the delay of the Air Filter unit, I’m looking at a third party option so I can get cutting in my office. Another thread says the Glowforge air flow is around 200 CFM. This scrubber claims 250-500 CFM capability: Does this seem like a good filter for a Glowforge? Are there other considerations I should be aware of? Or is there another filter that people recommend?

In fact, just searching for “filter” yields so much discussion. Make some popcorn and sit down and just read it all, you’ll be an expert in no time.

https://community.glowforge.com/search?q=filter

Supposedly, venting above roofline really reduces odor problems:

Re-vamped venting setup

For over a year, Trogdor and then Arges were ventilated with the tried-and-true dryer hose out the window method. My workshop is in the basement, so the only way to vent outside was out through a window well… [IMG_1363] For a variety of reasons, I wasn’t 100% satisfied with this setup. Do you know how hard it is to make an egress window air-tight?:tired_face: Over the past few months, I decided that exhausting out and up past our roofline was the way to go. Not only would it keep the exhaus…