Theres some sort of black stripping along the edge of the top of the outer glass pieces, where the mounts for the lid side hinges connect to the them. Mine doesnt have that. (could have been pulled off on mine for maintenance or re-assembly)
The gantry is screwed into the rails during shipment (you can see the red knobs etc), but on mine the screw mounts were in the center of the y-rails, where on this one they were all the way at the front.
The tube mounts are a bit more polished than mine,
The lower flap opens a LOT more easily.
Good tube =)
There are probably more, but those are the few that I noticed in the snippets
ohhhh I thought you meant an acrylic that was part metal to do engraving on. Yeah the case has metal foil on all the areas the laser could bounce to that arent covered by actual metal.
Theres also a speaker embedded in the bottom of the front facing downward for some reason. Maybe to communicate with the filter, or do a chime when a job finishes? Or sing daisy? Im not sure what is purpose is
Im assuming so, but I havent seen in theres to really know. I couldnt tell from the video @picciuto posted.Everything I know about @jules machine is from the engraves shes posted. I can tell theres a difference from the output. Mine has certain signature marks that are pretty noticeable.
That’s insane. I mean sure, technically you were sort of using their trademark, it really, not like people will actually do this (given they cost like $1 and yours costs essentially thousands of dollars in investment. You could probably fight it that this is an educational thing, but of course they realize it’s not worth it to you to fight (where is newegg’s legal team when you need them?)