Making Chamfers with GF

[marmak3261]

Here is another thread.

How to cut interior bevels

I’m looking at some designs where the outer edges of the product would have a beveled edge that narrows towards the top. The inner cutout of the product would have a beveled edges where the bevel matches the outer edge bevel. May I assume that I need to flip the product over for the second cut/bevel pass? My impression is that the GF laser is essentially pointed vertically downward (I’m open to being corrected). [image] The image on the left is a top view and the one on the right shows the bev…

And then this one

Angled cuts via engraving

I had an idea and wondered if anyone has ever seen angled miter joint type cuts created on a flat material using the laser to engrave the cut. This would allow someone to essentially print all the parts of a low poly papercraft type model out of wood and carefully piece/glue them together at the correct angles. Obviously the laser would have to be extremely well calibrated to the substrate being cut to allow for this accuracy in depth and engraving to create/simulate the “miter cut”. This wou…