Not starting loop or saying the item has to be .5" high to cut

mjaiser · November 4, 2018, 5:46pm

Not fully automated but that it would automatically line up the project being worked on each time you dragged the material up

Jules · November 4, 2018, 5:52pm

That’s what we do with the Snapmarks. Press a button and the parts align. That part is still under development for the Passthrough, but I imagine it will be something very similar.

mjaiser · November 4, 2018, 5:57pm

Yep, just looked up the function. Hopefully it gets implemented for all users. Want it so bad

I’m guessing you have it as an option. What’s it like?

Jules · November 4, 2018, 6:25pm

It’s angels and unicorns. Every bit the magic Dan promised. (i try not to rhapsodize too much, since I know most folks don’t have it yet.)

mjaiser · November 4, 2018, 6:29pm

Tell me more, tell me more
Did you get very far?
Tell me more, tell me more
Like does it have a clean OS?
Uh-huh uh-huh uh-huh uh-huh

Jules · November 4, 2018, 6:32pm

Sandy-Grease

wesleyjames · November 4, 2018, 6:45pm

I see GF implemented the automatic rotation for selfie pics.

Jules · November 4, 2018, 6:46pm

I only wish!

pip · November 4, 2018, 10:05pm

I extracted the logs to investigate the problem you reported, and I noticed that sometimes the red laser was missing the material, or striking it on the side which confused the image processor.

Any time the red laser hit material (as opposed to the crumb tray) the error wasn’t thrown.

I hope this helps.

I’m going to close this thread - if the problem reoccurs, go ahead and post a new topic. Thanks for letting us know about this!