Orange foam on laser tube?

jonathank005 · May 6, 2021, 4:52am

Does anyone know if I am suppose to remove this orange foam that is attached to the end of the laser in the Glowforge Plus?

geek2nurse · May 6, 2021, 4:59am

If it’s not mentioned in the unboxing and setting up instructions I’d leave it alone.

jonathank005 · May 6, 2021, 5:00am

Oh ok. Yea after inspecting it more. It seems its part of the laser tube. Thanks for the reply.

Angie.C · May 6, 2021, 7:31pm

Thanks for the answer @geek2nurse, that’s right. I’m going to close this thread - if you have any other questions, feel free to go ahead and post a new topic. Thank you!