Photos on cedar

I was wondering if anyone had suggestions on how to put a photo on cedar?

This is the standard to measure all photo preparation by:

It’s pretty easy though without any prep. All you need is the photo and a vector rectangle. You will get an image. If you are lucky, it might even be good enough not to need any digital enhancing.

Open either the vector or the photo in the GFUI. Then add artwork, the other image that you didn’t open. Set focus on the cedar in the bed.

Read this topic for getting the settings. It would be good to test ahead of time and have some different material. Folks often don’t mask when engraving photos.

6 Likes