Pocket watch box (Dr. Who)

[aanden]

It’s already there

EVA Foam Settings for Cosplay Projects

Thanks, this was very helpful as a starting point for 10mm EVA foam with the Basic. First try was Speed 275 Power 100 Passes 3 This cut through, but melted the under edge and left it undesirable. Speed 275 Power 100 Passes 2 This cut through mostly, but several places had to be finish cut with a knife. Speed 325 Power 100 Passes 3 This cut through, and left the lower edge mostly intact on 10mm EVA. I think theres a sweet spot with lower power 80? with 3 passes at the 275 - 300 spe…

EVA Foam Settings for Cosplay Projects

[2020-01-04 14.56.56] I personally used 325 speed 100 power and but the one pass. This is 5mm EVA foam [20200111_141842] I got this foam from Joann’s but good luck finding it. They had 5 different foams 3 of them NOT laser safe in 5 different areas. be very certain of the foam type. This stuff is totally laser safe.