Proofgrade hardwood too thin


#1

Hi support!

A section of a :proofgrade: cherry hardwood was much thinner than the rest of it (also, parts of the board had no finish on one of the sides). I didn’t quite notice until I cut pieces out of it.

See this picture taken on edge of two pieces cut from this piece of hardwood.

Here’s measurements. The 3.something mm is pretty much exactly 1/8".


#2

Hi @thejambi, I’m sorry for the delayed post here. I see we’ve been following up via email!

I’ll close this post. If you have any other questions, please let us know.


#3