Receiving a measuring error on an item that is 1.8”

[deirdrebeth]

This might help you out:

No-Math Focus Ruler

Leveraging the recently-released Set Focus tool, I’ve designed a tool to help place materials when the crumb tray has been removed, no maths required. If your material is between the lines while resting on the bottom of your GF – not the crumb tray, you should be able to use Set Focus in the UI. If the top of your material is below the bottom line, use your favorite method (sheets of PG, tiles, 3-D printed stands, matching sets of trained hedgies, etc.) to elevate it and recheck. Repeat until …

As long as the part of your item that you want to engrave falls into the zone, you should have no problem