Red cable getting caught on heatsink

[dklgood]

Here is the link and what support told someone that had a similar problem.

Red Cable hanging up on Heat Sink Fins - fixed

I made a cut out of the boots for holding the crumb tray in place( which works great ). So I wanted to do some test to see where the cut region would be with the new placement of the crumb tray. I placed masking on the crumb tray and started a low power cut. I noticed that the cut wasn’t even along the bottom and appeared to be skewed. I followed the calibration instructions for perfect square multiple times but no success. https://glowforge.com/support/topic/troubleshooting/perfect-squares …