Set Focus is refocussing in a different spot and failing to engrave

Iā€™m going to take your word for it. Iā€™m good at some things, great at others, but horrible at math. :slight_smile:

1 Like

I am sorry that we missed this thread. When you use the set focus feature it takes a measurement in the square at an approximate point. The best way to tell if it is landing at the desired point is to watch the red laser dot. If the red dot is not in the right place, move the set focus box and try again.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.