Specifications

[joe]

It is very dependent on the material. I cut through a 0.5" soft pine molding quite easily.

Baseboard Molding cut with a Glowforge

TLDR: I used the trace function and I cut through 0.5" of wood in a single pass. When we were fixing up the nursery for my daughter, I replaced all the baseboard trim in the room. Unfortunately, I missed a small section behind the door. It was only about 2" in length, but I had the other trim up, and I returned the Miter saw I borrowed. What to do? I decided to cut the profile into the short segment, that way it would fit flush. My plan was to do it with the dermal or jig saw. But wait, I ha…